OFF-STENTER SHEAR CUT TRIM SYSTEM
The shear cut trim system developed by Tandematic. Eliminates problems commonly associated with conventional high speed blade systems,and has gained acceptance world-wide as the premier method for selvedge trimming.
- The point of cutting can be set to be within 6 mm from holes of innermost row of stenter pins
- The low speed shear cutter blades will trim satisfactorily for a much longer period before. Needing to be changed – 1 month between resharpening/replacement is not uncommon
- Trimmed selvedge waste will never remain on the stenter pins after trimming and return on The pin chain. If stenter speed is limited by unreliable pick-up and removal of selvedge waste From the pins after trimming, especially as a result of a mis-pin at the entry, the tandematic Off-stenter trim system will remove this bottleneck and make possible increased stenter speed.
Following a mis-pin, fabric will return to its previous position and trimming will resume without operator attention.
Be aware of copies – insist on the genuine Tandematic trim system! Reduced trim waste = increased fabric yield = more profit.